Features:
- Superior beam quality, power stability and rugged reliability
- Industry leading compact size with integrated RF power supply
- Air and liquid cooled configurations available high quality laser processing on a wide range of materials
CR Lasers parameters
CR30C / CR40C
CR30C
Model | CR30C |
---|---|
Wavelength | 10.6 µm |
Power | >30W |
Power stabilit | <±5% |
Mode | m2 <1. 2 |
Beam diameter | 2±0.2mm |
Divergence angle | <7mrad |
Polarization | >100: 1, Horizontal linear polarization |
Modulation frequency | 0-25kHz, 0-100% |
Electrical input | 48VDC, 12. 5A |
Cooling method | Air cooled/Water cooling 4L/M |
Heat dissipation | 500W |
Size | Air cooled 360 X 93 X 145, Water cooling 360 X 93 X 95 |
Life | 20000 hours (Inflatable) |
Warranty time | 2 years |
CR40C
Model | CR40C |
---|---|
Wavelength | 10.6 µm |
Power | >45W |
Power stabilit | <±5% |
Mode | m2 <1. 2 |
Beam diameter | 2±0.2mm |
Divergence angle | <7mrad |
Polarization | >100: 1, Horizontal linear polarization |
Modulation frequency | 0-25kHz, 0-100% |
Electrical input | 48VDC/10A |
Cooling method | Air cooled/Water cooling 4L/M |
Heat dissipation | 500W |
Size | 357X93 X 145 Air cooled/ 357 X 93 X 95 Water cooling |
Life | 20000 hours (Inflatable) |
Warranty time | 2 years |
Pulse width modulation (PWM):
Laser is controlled laser power by Pulse width modulation (PWM). The low voltage range should be 0 to 0.5V (laser off), the high voltage, ranges should be +3.5V to +5V (laser on). Pulse width modulation or PWM, controls laser power by varying the duty cycle which is supplied by the external controller. The modulation frequency is 0-20KHZ. The duty cycle is 0-100%.
Specific steps are as follows:
- 48VDC power access to laser power input terminal block. +connect+, -connect-.
- The external controller signals access to laser BNC connector through Coaxial cable. The inner core of BNC connector connects with + of PWM signal. The shell of BNC connector connects with ground of PWM signal.
- Open the DC power, at this time the green indicator should illuminate (shown that Laser has been normally powered). PWM signal is set to a certain duty cycle by Controlling card software on the computer, at this time the red indicator should illuminate (shown that it has laser output).
Size | CR30C, CR40C |
---|